Please wait while we prepare your presentation...

Programming the SIB™


Introduction
SiB™ vs SID mode
Programs in SiB™ mode
Programs in SID mode

Commands
A - Z
Configuration
Programming
Time
GPIO
Sensor
Messaging


Introduction

The SiB™ is programmed via sequences of short commands, sent via IM. While many commands can be sent to the SiB™ to run immediately, like "TEMP" to read the temperature, other commands can only be used in specific sequences to make up a "program".

The SiB™ can store multiple programs at the same time, and run programs in a variety of ways:
- upon pressing the button
- after a specific sequence of button presses (example: short short short long)
- on a timed loop (example: every 20 minutes)
- by an external sensor
- by a messaged command